Trouble portabilizing app - where to start troubleshooting?
Posted: Tue Jun 03, 2008 6:32 pm
I recently made few application portable with the JPE autowizzard (2.0.3) and didn't run into much problems.
One application however gives me trouble (it's PhotomatixPro 3.0.3). When I run the PhotomatrixPro_portable file from the directory where the application has been installed, it runs fine. When I copy the whole thing to another location, I get an error mesage. I also tried unpacking the installation file (with Universal Extractor) and then run the JPE wizzard, but the same error comes up (see below).
Is there any way to troubleshoot this problem? I wouldn't even know where to begin looking. Is this something, that can be tackled or is this a hopeless endeavour?
BTW: Here's the error message, I get:
---------------------------
PhotomatixPro.exe - Common Language Runtime Debugging Services
---------------------------
Application has generated an exception that could not be handled.
Process id=0x6c4 (1732), Thread id=0x848 (2120).
Click OK to terminate the application.
Click CANCEL to debug the application.
---------------------------
OK Cancel
---------------------------
Thx!
- p
One application however gives me trouble (it's PhotomatixPro 3.0.3). When I run the PhotomatrixPro_portable file from the directory where the application has been installed, it runs fine. When I copy the whole thing to another location, I get an error mesage. I also tried unpacking the installation file (with Universal Extractor) and then run the JPE wizzard, but the same error comes up (see below).
Is there any way to troubleshoot this problem? I wouldn't even know where to begin looking. Is this something, that can be tackled or is this a hopeless endeavour?
BTW: Here's the error message, I get:
---------------------------
PhotomatixPro.exe - Common Language Runtime Debugging Services
---------------------------
Application has generated an exception that could not be handled.
Process id=0x6c4 (1732), Thread id=0x848 (2120).
Click OK to terminate the application.
Click CANCEL to debug the application.
---------------------------
OK Cancel
---------------------------
Thx!
- p